Once all fields have been entered and confirmed correct, click the Add button. Export to Group – Leave this box checked! Synchronize Device Time – Leave this box UN-checked! This password would have been setup by CLEAR IT SECURITY. Password: This is the password used on or setup on the Hikvision system. This name may be admin or a different name if setup by CLEAR IT SECURITY. User Name: This is the username assigned to you by CLEAR IT SECURITY or the system’s default username/password information. Port: 8000 (unless your installer used a custom port) If your system was installed by CLEAR IT SECURITY, this information would have been emailed to you. Example: Home or Office or JWG Warehouse Building 1, etc.Īddress: Enter the IP address or Dynamic DNS name for the device. This nickname is used to identify your system/location in the iVMS-4200 client. Nickname: Enter a Nickname for this location’s device. The most commonly used modes encountered here are IP/Domain and Cloud P2P.

The screen once open, will default to an Adding Mode of IP/Domain. If you are adding a device that is on the internet, you should click Add + under Device for Management (0) near the top middle area of your screen.If you are adding a device that is on your local network, you should see it listed at the bottom under Online Device (1) - if you do, just click on it then click Add + under Online Device (1).To add a new device, click on the Add located under Device for Management heading or:

Once you have downloaded and installed Hikvision’s iVMS-4200 Client, you can open iVMS-4200 and use the Device Management screen found in the Device Management tab (shown below) and to add, configure new and existing devices, as well as remove devices.

Ivms 4200 port is occupied